Champion Sidecars DAYTONA 2+2 Specifications

1 CHAMPION SIDECARS DAYTONA 2+2 AND ESCORT OWNERS MANUAL GL 1500 with GL 1800 supplement Champion Sidecars Inc. 11841 Monarch St

10 (CUT OUT TEMPLET) CONTINUED LOWER FRONT MOUNT 5. Install the 8mm x 100 mm bolt, flat washer and lock washer as shown and han

11

12 ( Fig D -1) (Fig D -2)

13 hand tight at this time, but will be torqued to 55ft.lbs. during the front strut installation.

14 4. Place the fairing panel on a flat surface and mark the position of the hole using dimensions shown (Figure G). If required, trim the corner

15 (Fig I)

16 Remove the right side panel/battery cover if you have not already done so. Also at this time remove the right passenger floor board and filler p

17 (Fig k-1) BRAKES (IF EQUIPPED) With the exception of Harley Davidson the sidecar brakes on most bike applications are integrated

18 at the front and rear cross member on 4x4 blocks or stands adjusted to a length of six and a half inches for the rear and seven and a half inches

19 frame and the upper mounts slightly for strut installation (only turn the top front frame eye clockwise for this adjustment). After the pinch bol

2 TABLE OF CONTENTS PAGE SPECIFICATIONS------------------------------- 3 Informatio

20

21 Figure L, is showing the correct frame height and location of measurement points for the Daytona and the Es

22 STEERING DAMPER INSTALLATION (1988 TO 1998) MARKLAND BACKREST INSTALLATION (There are no provisions fro

23 DRIVING A SIDECAR NEW OWNER DRIVING AND SAFETY PRECAUTIONS It is important to know that driving a sidecar will be nothing like riding a solo mo

24 wants to come around the motorcycle when stopping. If you are stopping and you do not have a brake you may want to counter steer into the sidecar

3 Helpful hints and safety precautions for the first time sidecar rider and sidecar passenger. Also information regarding what to expect when you t

4 Disconnect the wiring harness plug, brake quick coupler, and steering damper if you are using one. Now slide the sidecar away from the motorcycle.

5

6 ELECTRICAL SIDECAR POWER CONNECTOR (sidecar side) Motorcycle Wiring Diagram Code Pin # Description Color Gau

7 use the accessory terminal to control a relay that feeds this. This will prevent overloading the accessory circuit on your bike. * Brake Lights R

8 GOLDWING GL-1500/6 RH Mounting Instructions PREPARATION AND MOUNTING PROCEDURES NOTE; Reference to LH (left

9 4. Remove the 10mm frame bolt (Figure A #2) next to this hole for installation later. Position the arm assembly so the side plate is between